Selasa, 11 Januari 2011

Beranda » WIRELESS SWITCH

WIRELESS SWITCH

Normally, home appliances are controlled by means of switches, sensors, etc. However, physical contact with switches may be dangerous if there is any shorting. The circuit described here requires no physical contact for operating the appliance. You just need to move your hand between the infrared LED (IR LED1) and the photo transistor (T1).

Working
The infrared rays transmitted by IR LED1 is detected by the
photo transistor to activate the circuit. This circuit is very stable and sensitive compared to other AC appliance control circuits. It is simple, compact and cheap. Current consumption is low in milliamperes. The circuit is built around an IC CA3140, IR LED1, photo transistor and other discrete components. When regulated 5V is connected to the circuit, IR LED1 emits infrared rays, which are received by photo transistor T1 if it is properly aligned. The collector of T1
is connected to non-inverting pin 3 of
IC1. Inverting pin 2 of IC1 is connected to voltage-divider preset VR1. Using preset VR1 you can vary the reference voltage at pin 2, which also affects sensitivity of the photo transistor. Op-ampIC1 amplifies the signal received from the photo transistor. Resistor R3 controls the base current of transistor BC548 (T2). The high output
of
IC1 at pin 6 drives transistor T2 to energise relay RL1 and switch on the appliance, say, hand dryer, through the relay contacts. The working of the circuit is simple. In order to switch on the appliance, you simply interrupt the infrared rays falling on the photo transistor through your hand. During the interruption, the appliance remains on through the relay. When you remove your hand from the infrared beam, the appliance turns off through the relay. connect +5V supply to the circuit.

Circuit Diagram


Click the Diagram for better Quality

Tidak ada komentar:

Posting Komentar

Diberdayakan oleh Blogger.